Embroidering With Optional Free Arm Hoop C - ELNA 8600 Instruction Manual

Embroidering with Optional Free Arm Hoop C

q
The dimension of the leg or sleeve opening must be
large enough to allow the hoop to move freely. Insert the
w inner hoop of large hoop B w into the opening q. If the
inner hoop cannot be easily inserted, the opening is too
narrow for free arm embroidery.
e
Maximum distance for design position inside the opening
from the edge is 200 mm (7 7/8˝) e. Draw centerlines r
for design placement.
r
Remove extension table. See page 8.
Select hoop "C" in Edit Mode.
Select design or letters (dimensions of design/letters
y
must be 49 mm or less).
NOTE: Built-in designs less than 49 mm are 3, 9, 18, 19,
t
20, 21, 22, 23, 24, 29, 30, 34, 35, 36 and 44.
Hoop fabric, aligning centerlines r with hoop template
t.
Place fabric around free arm and lock hoop onto
carriage. Roll up fabric edges so they will not be caught
at the neck of the free arm during embroidery sewing.
Insert the blocking plate (stored in the arm of the hoop)
y next to the hoop opening. The blocking plate prevents
the fabric edge on the free arm from rolling back into the
embroidery area.
Touch the "Jog" keys to position needle directly over
centerlines.
Sew design.
CAUTION: Immediately remove hoop from free arm after
sewing is completed. Never attempt to select a new
design, change modes or switch off machine without first
removing the hoop from the free arm.
y
110