ELNA 8600 Instruction Manual page 59

q
Restart for the same size.
Different size
5.0
1
5.0 4.0
Cancel
Default Default
9
Cancel Cancel
OK OK
5.0 6.0
Setting Memory Darning Size
To darn a length less than 2 cm (3/4˝) q, stop the
machine after sewing the desired length and press the
"Reverse" key. The darning length has now been
determined. Restart and sew until the machine stops
automatically.
To sew another darning cycle with same size - raise foot,
move fabric, lower foot and sew.
Reset Darning Cycle Size
To sew darning with a different size (or width/length
adjusted), reset the machine by touching "Cancel" key.
Sew new darning size using same method.
To Adjust the Evenness of Darning Stitches
Fabric and the number of layers can affect darning. If
one side of darning is higher or lower than the other,
make them even by touching the "Adjust" key.
If left corner is lower than right side, touch "–".
If left corner is higher than right side, touch "+".
NOTE: 5.0 is default setting. Evenness can be set
between 1.0 and 9.0.
58