Built-In Needle Threader - ELNA 8600 Instruction Manual

Built-in Needle Threader

Press the "Up/Down Needle" key until the needle is in an
up position. Turn OFF the power switch. Lower the
presser foot.
Pull down the needle threader lever q as far as it will go.
Hook w is automatically inserted into the needle eye.
q
w
Bring the thread around guide e and under hook w.
e
w
Slowly release the lever while holding the thread end
and let the needle threader return to its original position.
A loop of thread r is pulled through the needle eye.
r
Pull the thread loop off the guide to the back and
manually bring the thread through the needle eye.
NOTE: The needle threader can be used with #11 to #16
size needles. Thread weight may vary from 30 to 100.
If the needle threader does not catch a thread loop,
check the needle and positioning.
28