Setting The Camera Position And Action - Preset Position Setting Page (Brc-300, Evi-D100, Evi-D70 Only); Preset Channel Selection Section - Sony Ipela SNT-V704 User Manual

You can specify up to 10 IP addresses and subnet mask
values. For a subnet mask, type 8 to 32.
To temporarily cancel the Default Policy for a specified
IP address/subnet mask, select Allow or Deny from the
drop-down list on the right.
Tip
The subnet mask value represents the bit number from
the left of the network address.
For example, the subnet mask value for 255.255.255.0 is
24.
If you set "192.168.0.0 / 24, Allow," you can allow
access from the computers having an IP address between
192.169.0.0 and 192.168.0.255.
OK/Cancel
See "Buttons common to every setting page" on page
27.
Setting the Camera Position and Action — Preset position setting Page (BRC-300, EVI-D100, EVI-D70 only)
Setting the Camera
Position and Action
— Preset position setting Page
(BRC-300, EVI-D100, EVI-D70
only)
When you click Preset position on the Administrator
menu, the Preset position setting page appears.
Use this page to store the pan, tilt and zoom positions of
the camera (Preset position) in memory and program the
sequenced action of the cameras (Tour).

Preset Channel Selection Section

To store the position and action of each camera (preset
position), select the channel to which the camera you are
going to set this function is connected; CH1, CH2, CH3
or CH4.
To program the tour by using the preset position stored
in each camera, select Tour.
When you select channel CH1, CH2, CH3 or CH4,
"Preset Position section" is displayed. "Preset Position
section" includes "Position preset section", "Position at
alarm section" and "Preset position table section".
When you select Tour, "Tour Schedule setting section"
is displayed. "Tour Schedule setting section" includes
"Tour setting section", "Tour selection section" and
"Tour table section".
41