Setting The Alarm Buffer; Alarm Buffer Setting Page; Alarm Buffer Channel Selection Section; Alarm Buffer Video Mode Section - Sony Ipela SNT-V704 User Manual

Setting the Alarm Buffer

— Alarm buffer setting Page

When you click Alarm buffer on the Administrator
menu, the Alarm buffer Setting page appears.
Use this page to set up for the alarm buffer used in the
FTP client function (see page 45) and the Image
memory function (see page 53).
Alarm Buffer Channel Selection
Section
Select the channel where you want to use the alarm
buffer function. When you select the channel, the Alarm
buffer Video Mode and Alarm buffer setting pages
appear.
The channel number is the same as the connector
number t1 to 4 to which the camera is connected on
this unit

Alarm buffer Video Mode Section

Video Mode
The video mode set in the Video mode of the Video
setting page (see page 36) is displayed.
MPEG4: Shows the present output format of the camera
is MPEG4.
JPEG: Shows the present output format of the camera is
JPEG.

Alarm buffer setting Section

xWhen the Video Mode is set to JPEG
Recording interval
Select the interval (in seconds) at which you want to
record an image in the alarm buffer.
You can select from among the following intervals:
For the NTSC cameras:
1/30, 1/15, 1/10, 1/5, 1/2, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
(seconds)
For the PAL cameras:
1/25, 1/12, 1/8, 1/5, 1/2, 1, 2, 3, 4, 5, 6, 7, 8, 9, 10
(seconds)
Pre-alarm images
Type the number of images to be recorded before
detecting an alarm (Pre-alarm).
Post-alarm images
Type the number of images to be recorded after
detecting an alarm (Post-alarm).
Maximum alarm images
Displays the maximum number of images that can be
recorded in the alarm buffer with the current image size
and image quality.
Note
The number of Maximum alarm images differs
depending on the Image size and Image quality settings
on the Video setting page.
Check the Maximum alarm images setting and set so
that the total number of Pre-alarm images and Post-
alarm images does not exceed the Maximum alarm
images.
If you set both Pre-alarm images and Post-alarm images
to 0, only one image is recorded at the moment when an
alarm is detected.
OK/Cancel
See "Buttons common to every setting page" on page
27.
xWhen the Video Mode is set to MPEG4
Pre-alarm period
Set the time to be recorded before detecting an alarm
(Pre-alarm).
Post-alarm period
Set the time to be recorded after detecting an alarm
(Post-alarm).
Setting the Alarm Buffer — Alarm buffer setting Page
57