Initialization Section; Setting The Sound - Sound Setting Page; Sound Setting Section - Sony Ipela SNT-V704 User Manual

This setting is valid when the Synchronization with NTP
server menu is set to On.
Interval time
Select the interval at which you want to adjust this unit's
time referring to the NTP server' time, between 1 and 24
hours. The set interval is a guide, and does not indicate
the exact time.
This setting is valid when the Synchronization with NTP
server menu is set to On.
Note
The time adjusted by this function may be slightly in
error depending on the network environments between
this unit and the NTP server.

Initialization Section

Backup setting
Saves the setting data of this unit in a file.
Click Save, and follow the instructions on the browser to
specify the folder and save the setting data of this unit.
The file name preset at the factory is "snt-v704.cfg."
Restore setting
Loads the stored setting data of this unit.
Click Browse and select the file in which the setting data
is stored. Then, click Apply, and this unit is adjusted
according to the loaded data and restarted.
Reboot
Reboots this unit.
Click Reboot, and "The SNT-V704 will be rebooted.
Are you sure?" appears. Click OK to reboot this unit.
Factory default
Resets this unit to the factory settings.
Click Factory default, and "All configuration
information will be initialized as factory setting. Are
you sure?" appears. Click OK to reset to the factory
settings.
Note
When the unit carries out any operation of "Reboot,"
"Factory default" and so on and disconnects the
computers connected to the unit as the users, "Service
ends." is displayed on all connected computers.
30
Setting the Sound – Sound setting Page
Setting the Sound
– Sound setting Page
When you click Sound on the Administrator menu, the
Sound setting page appears.
Use this page to set the functions of the audio.

Sound setting Section

Microphone
Select whether you send the audio from the m
microphone input connector. Select On to send the
audio input to this unit.
Mic Volume
Set the volume level of the audio input from the m
microphone input connector or the o (line in)
connector. It is adjustable from –10 to +10.
Speaker output
Set whether the received audio is output to the speaker
(active speaker for example) connected to the
output) connector on this unit.
Select On to accept the audio data transmission.
OK/Cancel
See "Buttons common to every setting page" on page
27.
(line