Setting Up; Initial Settings - Sony PWS-110RX1A Operation Manual

Setting Up

Initial Settings

Before using the unit, configure the Windows settings
within the unit. The description below describes the
settings in Windows 10.
Note
To reboot the unit, first shut down the unit and then turn the On/Standby
button on the front panel on again, without rebooting Windows.
1
Connect a keyboard and mouse to the USB connectors
on the front panel, and connect a monitor to the HDMI
connector on the rear panel.
2
Set the On/Standby button to the On position.
3
When the Windows sign-in screen appears, enter
"rx1" as the user name, enter "rx1" as the password,
and sign in.
Setting the Windows interface language
1
Hold down the Windows key and press the X key, then
select [Control Panel] from the displayed menu.
2
Select [Clock, Language, and Region] > [Language].
3
Select [Add language] to add a language.
4
Select the language to add, then click [Add].
5
Select the language to use and click [Move up] until
the language is displayed at the top.
6
Sign out and then sign in again.
Configuring the network
1
Connect a LAN cable to the LAN1 connector on the
rear panel of the unit. Connection and network settings
for the user environment are required.
2
Click [View network status and tasks] under [Network
and Internet] in the control panel.
3
Click the device connected by the LAN cable in
[Connections].
4
Click the [Properties] button.
16
Setting Up
5
Select [Internet Protocol Version 4 (TCP/IPv4)], then
click the [Properties] button.
6
Change the IP address and other settings.
7
Click the [Advanced] button to configure DNS, and
other settings.
8
When finished, click the [OK] button.
Setting the date and time
1
Select [Set the time and date] under [Date and Time]
in the [Clock, Language, and Region] control panel.
2
Click [Change time zone] on the [Date and Time] tab,
and select the time zone.
3
Click [Change date and time] on the [Date and Time]
tab, and set the date and time.
4
Click the [Change settings] button on the [Internet
Time] tab.
5
Specify an NTP server, then click the [Update Now]
button.
6
Place a check mark in [Synchronize with an Internet
time server] to periodically correct the clock using the
NTP server.
Setting user passwords
The "rx1" default user is configured for Windows within
the unit. Set the password for the user to provide security.
1
Click [User Accounts and Family Safety] in the
control panel.
2
Click [User Account] > [Change account type].
3
Select the "rx1" user.
4
Click [Change the password].
5
Enter a new password and a password hint, then click
the [Change Password] button.