Bandwidth Control Selection; Http Port Setting Section; Notifying The Ip Address - Dynamic Ip Address Notification Section - Sony Ipela SNT-V704 User Manual

Secondary DNS
Type the IP address of the secondary DNS server, if
necessary.
OK/Cancel
See "Buttons common to every setting page" on page
27.

Bandwidth control selection

Limits the data communication bandwidth for each
channel of this unit.
CH1–4 Bandwidth control
You can select from among the following:
Unlimited, 0.5, 0.6, 0.7, 0.8, 0.9, 1.0, 2.0, 3.0, 4.0, 5.0,
6.0, 7.0, 8.0 (Mbps)
Select Unlimited when you do not want to limit the
bandwidth.

HTTP port setting Section

You can set the port number for the HTTP server on this
unit.
HTTP port No.
Normally select 80. If you want to use a port number
other than 80, select the text box and type a port number
between 1024 and 65535.
Note
When you have set the HTTP port No. to a number other
than 80 on the Network setting page or in the Setup
Program, access this unit by typing the IP address of this
unit on the web browser, as follows:
Example: when HTTP port No. is set to 8000
38
Configuring the Network – Network setting Page
Notifying the IP Address
— Dynamic IP address notification
Section
When the DHCP menu is set to On, you can send the
notification of the completion of the network settings
(Wired LAN settings and Wireless LAN settings) using
the SMTP or HTTP protocol.
SMTP
Select On to send an E-mail when the DHCP setting is
completed.
Recipient e-mail address
Type the recipient E-mail address up to 64 characters.
You can specify only one recipient E-mail address.
Subject
Type the subject/title of the E-mail up to 64 characters.
Message
Type the text of the E-mail up to 384 characters. You
can describe the information of the acquired IP address,
etc. using the special tags mentioned below.
HTTP
Select On to output a command to the HTTP server
when the DHCP setting is completed. Using this
function, you can configure a useful system, for
example, to view the access log stored in the HTTP
server or start an external CGI program.
URL
Specify the URL to send HTTP commands, up to 256
characters. The URL is normally described as follows:
http://ip_address:port/path?parameter
ip_address: Type the IP address or host name of the host
to which you want to connect.