HP Point of Sale rp5000 Troubleshooting Manual page 61

Numeric Codes and Text Messages (Continued)
Code/Message
605-Diskette Drive
Type Error
610-External Storage
Device Failure
611-Primary Floppy
Port Address
Assignment Conflict
612-Secondary
Floppy Port Address
Assignment Conflict
660-Display cache is
detected unreliable
916-Thermal Sensor
from Processor
Heatsink is not
Connected
917-Expansion Riser
not Detected
Troubleshooting Guide
Probable Cause
Mismatch in drive type.
External tape drive not
connected.
Configuration error.
Configuration error.
Integrated graphics
controller display cache
is not working properly
and will be disabled.
Processor heatsink
cable not connected to
system board.
Riser board not seated
or not installed.
www.hp.com
Recommended Action
1. Run Computer Setup.
2. Disconnect any other diskette
controller devices (tape drives).
3. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
Reinstall tape drive or press F1 and allow
system to reconfigure without the drive.
Run Computer Setup.
1. Run Computer Setup.
2. Remove expansion cards.
3. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
Replace system board if minimal graphics
degrading is an issue.
Reseat or replace the processor heatsink
cable going to the system board.
Install riser board if missing or remove
and reseat to ensure good connection.
POST Error Messages
Appendix B,
Appendix B,
A–7