HP Point of Sale rp5000 Troubleshooting Manual page 60

POST Error Messages
Numeric Codes and Text Messages (Continued)
Code/Message
410-Audio Interrupt
Conflict
411-Network
Interface Card
Interrupt Conflict
501-Display Adapter
Failure
510-Splash Screen
image corrupted
511-CPU Fan not
detected
601-Diskette
Controller Error
602-Diskette Boot
Record Error
A–6
Probable Cause
IRQ address conflicts
with another device.
IRQ address conflicts
with another device.
Graphics display
controller.
Splash Screen image
has errors.
Fan is not connected or
may have
malfunctioned.
Diskette controller
circuitry or floppy drive
circuitry incorrect.
Diskette in Drive A not
bootable.
www.hp.com
Recommended Action
Reset the IRQ.
Reset the IRQ.
1. Reseat the graphics card
(if applicable).
2. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
3. Verify monitor is attached and turned
on.
4. Replace the graphics controller.
Install latest version of ROMPaq to restore
image.
1. Reseat fan cable.
2. Replace the fan.
1. Run Computer Setup.
2. Check and/or replace cables.
3. Clear CMOS. (See
"Password Security and Resetting
CMOS.")
4. Replace diskette drive.
5. Replace the system board.
Replace the diskette.
Appendix B,
Appendix B,
Troubleshooting Guide