Remote Management And Nat; System Timeout; Www Screen; Figure 89 Www Remote Management - ZyXEL Communications P-334WH User Manual

P-334WH User's Guide
3 There is already another remote management session with an equal or higher priority
running. You may only have one remote management session running at one time.
4 There is a firewall rule that blocks it.

16.1.2 Remote Management and NAT

When NAT is enabled:
• Use the ZyXEL Device's WAN IP address when configuring from the WAN.
• Use the ZyXEL Device's LAN IP address when configuring from the LAN.

16.1.3 System Timeout

There is a default system management idle timeout of five minutes (three hundred seconds).
The ZyXEL Device automatically logs you out if the management session remains idle for
longer than this timeout period. The management session does not time out when a statistics
screen is polling. You can change the timeout period in the System screen

16.2 WWW Screen

To change your ZyXEL Device's World Wide Web settings, click Management > Remote
MGMT to display the WWW screen.

Figure 89 WWW Remote Management

The following table describes the labels in this screen.

Table 68 WWW Remote Management

LABEL
Server Port
Server Access
164
DESCRIPTION
You may change the server port number for a service if needed, however you must
use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the ZyXEL Device
using this service.
Chapter 16 Remote Management Screens