Rule Configuration With The Pre-Defined Service; Figure 86 Bandwidth Management Rule Configuration: Pre-Defined Service; Table 66 Bandwidth Management Rule Configuration: Pre-Defined Service - ZyXEL Communications P-334WH User Manual

P-334WH User's Guide

15.9.1 Rule Configuration with the Pre-defined Service

To edit a bandwidth management rule for the pre-defined service in the ZyXEL Device, click
the Edit icon in the Application List table of the Advanced screen. The following screen
displays.

Figure 86 Bandwidth Management Rule Configuration: Pre-defined Service

The following table describes the labels in this screen.

Table 66 Bandwidth Management Rule Configuration: Pre-defined Service

LABEL
#
Enable
Direction
Bandwidth
Destination Port
Source Port
Protocol
OK
Cancel
160
DESCRIPTION
This is the number of an individual bandwidth management rule.
Select an interface's check box to enable bandwidth management on that
interface.
These read-only labels represent the physical interfaces. Bandwidth management
applies to all traffic flowing out of the router through the interface, regardless of
the traffic's source.
Traffic redirect or IP alias may cause LAN-to-LAN traffic to pass through the
ZyXEL Device and be managed by bandwidth management.
Select Maximum Bandwidth or Minimum Bandwidth and specify the maximum
or minimum bandwidth allowed for the rule in kilobits per second.
This is the port number of the destination. See
common services and port numbers.
This is the port number of the source. See
common services and port numbers.
This is the protocol (TCP or UDP) used for the service.
Click OK to save your customized settings.
Click Cancel to exit this screen without saving.
Table 62 on page 154
Table 62 on page 154 for some
Chapter 15 Bandwidth Management
for some