Upgrading The Sccp Signaling Image - Cisco ATA186-I1 Administrator's Manual

Chapter 3 Configuring the Cisco ATA for SCCP
Click the Reset Phone button on the Phone Configuration screen. The Reset Device pop-up window
Step 6
appears.
Step 7 Click Reset.
A confirmation box appears. Click OK.
Step 8

Upgrading the SCCP Signaling Image

For instructions on how to upgrade the Cisco ATA to the most recent SCCP signaling image, refer to the
following list:
•
•
OL-4652-01
To use the recommended Cisco CallManager TFTP method of upgrading any or all Cisco ATAs at
one time, see the "Upgrading the Signaling Image Via Cisco CallManager" section on page
In the rare instance that you are not using the Cisco CallManager TFTP to configure the Cisco ATA
and to obtain software upgrades, you must manually upgrade to the latest signaling image
immediately after the Cisco ATA boots up. In this case, see the
Manually" section on page
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
7-4.
Upgrading the SCCP Signaling Image
"Upgrading the Signaling Image
7-2.
3-27