Cisco ATA186-I1 Administrator's Manual page 102

Tone Configuration Parameters
ReorderTone Parameter Example 2
Assume that you want a reorder tone in which:
The only frequency is 400 Hz.
•
The frequency plays six times, each time for 0.1 second followed by 0.9 second of silence.
•
The frequency then plays once for 0.3 second followed by 0.7 second of silence.
•
The volume of the frequency is –19 dBm.
•
The tone plays until another call event stops the tone.
•
For this reorder tone, make the following setting. See
ReorderTone:100,1,31164,1620,0,0,0,0,2,800,7200,2400,5600, 0,0,5,0
Table 5-6
Component
Sequential
NumOfFreqs
TFreq1
TAmp1
TFreq2
TAmp2
TFreq3
TAmp3
NumOfOnOffPairs
OnTime1
OffTime1
OnTime2
OffTime2
OnTime3
OffTime3
NumOfRepeats
TotalToneTime
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
5-32
Reorder Tone Parameter Example 2 Explanation
Setting Explanation
100 Required setting for a tone with one frequency
1 One frequency in the tone
31164 First frequency is 400 Hz
1620 First frequency volume is –19 dBm
0 No second frequency
0 No second frequency
0 No third frequency
0 No third frequency
2 Two on-off pairs in the cadence of the tone
800 Sound in first on-off pair plays for 0.1 second
7200 Sound in first on-off pair is followed by 0.9
second of silence
2400 Sound in second on-off pair plays for 0.3
seconds
5600 Sound in second on-off pair is followed by 0.7
second of silence
0 No third on-off pair in the cadence
0 No third on-off pair in the cadence
5 First on-off pair of the cadence plays six times
(plays once and then repeats five times), then
the second on-off pair plays
0 Tone plays continuously (set of two on-off
pairs of the cadence repeat continuously) until
another call event stops the tone
Chapter 5
Table 5-6 for a detailed explanation.
Parameters and Defaults
OL-4652-01