Table of Contents
Advertisement
Configuring the Unchannelized Mode
To continue your Cisco PA-MC-T3-EC port adapter installation, you must configure the PA-MC-T3-EC
interface. The instructions that follow apply to all supported platforms. Minor differences between the
platforms—with Cisco IOS software commands—are noted.
This chapter contains the following sections:
•
•
•
•
•
•
Upgrading the Field-Programmable Device Before Configuring
the T3 Mode
Before you can configure the T3 mode, you must upgrade the field-programmable device (FPD), if an
upgrade is required. An FPD upgrade requirement message appears when the hardware is installed and
it is recognized. The FPD upgrade is first available in Cisco IOS Release 12.4(15)T and is available in
future releases of Cisco IOS Release 12.4T.
You can perform the upgrade automatically or manually. The automatic upgrade method is preferred.
See the Field-Programmable Device Upgrades document for complete information at
http://www.cisco.com/en/US/docs/routers/7200/configuration/feature_guides/fpd.html.
Use the following FPD packages for your product:
•
•
•
OL-10589-02
Upgrading the Field-Programmable Device Before Configuring the T3 Mode, page 4-1
Using the EXEC Command Interpreter, page 4-2
Replacing an Existing Port Adapter, page 4-3
Configuring an Unchannelized T3 Link, page 4-4
Performing a Basic Serial Interface Configuration, page 4-14
Checking the Configuration, page 4-15
c7200p-fpd-pkg for NPE-G2
c7301-fpd-pkg for Cisco 7301
c7200-fpd-pkg for NPE-G1 and NPE-400
C H A P T E R
PA-MC-T3-EC Port Adapter Installation and Configuration
4
4-1
Advertisement
Table of Contents
