Resetting The Cisco Ata Using Cisco Callmanager - Cisco ATA186-I1 Administrator's Manual

Resetting the Cisco ATA Using Cisco CallManager

Follow these steps to set parameters using the web configuration page:
Procedure
Step 1 Make sure that your PC and the Cisco ATA are already networked and visible to each another.
Open your web browser.
Step 2
Enter the URL for your configuration page. The default URL for the web server is:
Step 3
http://IP Address/dev
For example, the configuration page for a Cisco ATA with the IP address 192.168.3.225 is:
http://192.168.3.225/dev
Select the values for the items that you want to configure. See
Step 4
a complete list of parameters and their definitions. Also see
listing of configurable features and references to their corresponding parameters.
Cisco strongly recommends that you set a password. Use the UIPassword parameter to configure a
Note
password, after which you are prompted for the password whenever you attempt to change a parameter
value. Configuration parameters cannot be accessed through the voice configuration menu if the
password contains one or more letters and can be changed only by using the web interface or the TFTP
configuration method.
Click apply to save your changes.
Step 5
The Cisco ATA automatically refreshes its configuration.
Close your web browser.
Step 6
Resetting the Cisco ATA Using Cisco CallManager
Whenever you make configuration changes to the Cisco ATA, you must reset the Cisco ATA using the
Cisco CallManager for these configuration changes to take effect. To reset the Cisco ATA, use the
following procedure:
Procedure
Go to the main Cisco CallManager Administration screen.
Step 1
Using voice configuration menu code 21, review the Cisco ATA IP address.
Step 2
From the Device pull-down menu, select Phone. The Find and List Phones screen appears.
Step 3
In the area next to the Find button, enter a portion or all of the Cisco ATA MAC address, then press Find.
Step 4
The Find and List Phones screen reappears, and now contains the Cisco ATAs that match the find criteria
you entered in the previous screen.
Click the icon of the Cisco ATA that you would like to reset. The Phone Configuration screen appears.
Step 5
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
3-26
Chapter 3 Configuring the Cisco ATA for SCCP
Chapter 5, "Parameters and Defaults,"
Table 3-5 on page 3-8 for an alphabetical
for
OL-4652-01