Obtaining Network Status After Getting Ip Connectivity - Cisco ATA186-I1 Administrator's Manual

Obtaining Network Status After Getting IP Connectivity

Obtaining Network Status After Getting IP Connectivity

Use the Cisco ATA Stats Web page
information:
•
•
•
•
Table 8-4
Bit Number
0
1
4
5
8
9
10
11
12
Example
If the hexadecimal value provided by the web configuration menu is 0x1011, the network status of the
Cisco ATA is shown in
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
8-12
VLAN ID: D0
tftpFile: S
NTP: D1,D2,D3
tftp: 0xX
where:
D0 is the VLAN ID. It should be non-zero if the Cisco ATA has entered a VLAN.
–
S is the tftp filename, which can be either ata<macaddress> or the filename supplied by the
–
DHCP server.
D1 is the local time on the Cisco ATA
–
D2 is the last NTP contact time
–
D3 is the last successful NTP contact time.
–
D1, D2, D3 values are shown in number of seconds since 00:00:00 UTC, 1970-01-01. If no NTP
response has been received from the NTP server, the values of D1, D2, and D3 are 0.
0xX is a bitmap value in hexadecimal format. The definition of each bit is shown in
–
Web Configuration Menu Network Status Bitmap
Description
Cisco ATA sent request for configuration file, ata<macaddress>, to TFTP server
Cisco ATA sent request for configuration file, atadefault.cfg, to TFTP server
Cisco ATA sent request for image file to TFTP server
Cisco ATA failed to upgrade to the downloaded image file
Configuration file is not found
Bad configuration file
Checksum error for configuration file
Decode error for configuration file (encryption related)
Configuration file is processed successfully
Table 8-5.
(http://<Cisco ATA IP address>/stats)
.
.
Chapter 8 Troubleshooting
to display the following
Table 8-4.
OL-4652-01