Conventions - Cisco ATA186-I1 Administrator's Manual

Conventions

Table 1 Cisco ATA 186 and Cisco ATA 188 Analog Telephone Administrator's Guide (SCCP) Organization (continued)
Chapter
Chapter 3, "Configuring the Cisco ATA for SCCP"
Chapter 4, "Adding the Cisco ATA to the
Cisco CallManager"
Chapter 5, "Parameters and Defaults"
Chapter 6, "Configuring and Debugging Fax Services"
Chapter 7, "Upgrading the Cisco ATA Signaling Image."
Chapter 8, "Troubleshooting"
Appendix A, "How to Use Pre-call and Mid-call Services"
Appendix B, "Voice Menu Codes"
Appendix C, "Cisco ATA Specifications"
Appendix D, "Performing a Cross-Protocol Upgrade"
Appendix E, "Recommended Cisco ATA Tone Parameter
Values by Country"
Glossary
Index
Conventions
This document uses the following conventions:
•
•
•
•
•
•
•
Means reader take note. Notes contain helpful suggestions or references to material not covered in the
Note
publication.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
xii
Alternative keywords are grouped in braces and separated by vertical bars (for example, {x | y | z}).
Arguments for which you supply values are in italic font.
Commands and keywords are in boldface font.
Elements in square brackets ([ ]) are optional.
Information you must enter is in
Optional alternative keywords are grouped in brackets and separated by vertical bars (for example,
[x | y | z]).
Terminal sessions and information the system displays are in
Description
Provides information about how to configure the Cisco ATA
and the different configuration methods you can use.
Provides information about adding the Cisco ATA to the
Cisco CallManager environment.
Provides information on the parameters and defaults that you
can use to configure the Cisco ATA.
Provides instructions for configuring both ports of the
Cisco ATA to support fax transmission.
Provides instructions for remotely upgrading Cisco ATA
software.
Provides basic testing and troubleshooting procedures for the
Cisco ATA.
Provides end-user procedures on how to use pre-call services
and mid-call services that the Cisco ATA supports.
Provides a quick-reference list of the voice configuration
menu options for the Cisco ATA.
Provides physical specifications for the Cisco ATA.
Provides instructions on changing from SCCP to a SIP,
MGCP or H.323 signaling image.
Provides tone parameters for various countries.
Provides definitions of commonly used terms.
Provides reference information.
font.
boldface screen
font.
screen
Preface
OL-4652-01