Epid0Orsid0 And Epid1Orsid1; Lbrcodec - Cisco ATA186-I1 Administrator's Manual

Chapter 5 Parameters and Defaults

EPID0orSID0 and EPID1orSID1

SIDx specifies whether to enable the Phone 1 and/or Phone 2 ports on the Cisco ATA to register with
Cisco Call Manager. (EPIDx is not for SCCP.) SIDx can be one of the following values:
•
•
•
•
Value Types
Alphanumeric string for each parameter
Range
Maximum 51 characters for each parameter
Voice Configuration Menu Access Codes
46 and 47 for EPID0orSID0 and EPID1orSID1, respectively

LBRCodec

Description
This parameter is used for selecting the low-bit-rate codec. The following values are valid:
•
•
When operating with a low-bit-rate codec, the Cisco ATA can support either two G.723.1 connections
or one G.729 connection. The selection of G.723.1 or G.729 must be statically configured. When
G.723.1 is the low-bit-rate codec, each FXS port is allocated with one G.723.1 connection. When G.729
is used, only one FXS port can use G.729.
If LBRCodec=0, then both Cisco ATA FXS ports can operate with the following codecs:
•
•
•
•
If LBRCodec=3, check the setting of bit 21 in the ConnectMode parameter (see the
section on page
If LBRCodec=3, then the Phone 1 FXS port can operate with the following codecs:
•
•
•
OL-4652-01
0—Disables port; port does not attempt to register with Cisco CallManager
. or <mac_address>—Uses the default Skinny ID, which is the Cisco ATA MAC address (MAC) for
the Phone 1 port and MAC[1-5]+01 for the Phone 2 port. The port attempts to register with
Cisco CallManager.
For example, if the MAC address of the Cisco ATA is 00012D01073D, then SID0 is 00012D01073D and
SID1 is 012D01073D01.
Other values are reserved.
0—Select G.723.1 as the low-bit-rate codec (available only for connections 0 and 2).
3—Select G.729A as the low-bit-rate codec (available only for connection 0). When G.729 is used,
only one FXS port can use G.729.
Number of codecs=3
Codec[0]=G.711µ -law
Codec[1]=G.711A-law
Codec[2]=G.723.1
5-21) to determine if G.729 is enabled for the Phone 1 or Phone 2 FXS port.
Number of codecs=4
Codec[0]=G.711µ-law
Codec[1]=G.711A-law
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
Network Configuration Parameters
"ConnectMode"
5-13