Cisco ATA186-I1 Administrator's Manual page 40

Specifying a Preconfigured VLAN ID or Disabling VLAN IP Encapsulation
Table 3-1
Parameter and Bits
OpFlags:
• Bit 4—Enable the use of user-specified voice VLAN ID.
• Bit 5—Disable VLAN encapsulation
Bit 6—Disable CDP discovery.
•
VLANSetting:
Bits 0-2—Specify VLAN CoS bit value (802.1P priority) for TCP
•
packets.
Bits 3-5—Specify VLAN CoS bit value (802.1P priority) for
•
Voice IP packets
Bits 18-29—User-specified 802.1Q VLAN ID
•
Table 3-2
Feature
Static VLAN
CDP-acquired
VLAN
No VLAN
No CDP
No CDP and no
VLAN
N/A indicates that the variable is not applicable to the feature and the setting of this variable does not affect the feature.
Example
The following procedure shows you how to configure the OpFlags and VLANSetting parameters to allow
the Cisco ATA to use a user-specified VLAN ID. In this example, the voice VLAN ID is 115 (in decimal
format).
Step 1 Set bits 4-6 of the OpFlags parameter to 1, 0, and 1, respectively. This setting translates to the following
bitmap:
xxxx xxxx xxxx xxxx xxxx xxxx x101 xxxx
The remaining bits of the OpFlags parameter, using all default values, make up the following bitmap
representation:
0000 0000 0000 0000 0000 0000 0xxx 0010
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)
3-4
Parameters and Bits for Preconfiguring a VLAN ID
VLAN-Related Features and Corresponding Configuration Parameters
OpFlags Bit 4 OpFlags Bit 5 OpFlags Bit 6
1
0
N/A
N/A
0
Chapter 3
0 1
0 0
1 N/A
N/A 1
1 1
Configuring the Cisco ATA for SCCP
Reference
OpFlags, page 5-24
VLANSetting, page 5-11
VLANSetting
Bits 18-29
VLAN ID
N/A
N/A
N/A
N/A
OL-4652-01