Specifying A Preconfigured Vlan Id Or Disabling Vlan Ip Encapsulation - Cisco ATA186-I1 Administrator's Manual

Chapter 3 Configuring the Cisco ATA for SCCP
4.
5.
Note
6.
7.
When the Cisco ATA is downloading its DHCP configuration, the function button on the top panel
Note
blinks.
Specifying a Preconfigured VLAN ID or Disabling VLAN IP
Encapsulation
If you want the Cisco ATA to use a preconfigured VLAN ID instead of using the Cisco Discovery
Protocol to locate a VLAN, or if you want to disable VLAN IP encapsulation, refer to
reference to the parameters and bits you may need to configure. Use the voice configuration menu to
configure these parameters. (See the
on using this menu.) Also, refer to
and bits to configure depending on your network environment.
Bits are numbered from right to left, starting with bit 0.
Note
OL-4652-01
The Cisco ATA contacts the Cisco CallManager TFTP server and downloads the appropriate .xml or
.cnf configuration file that allows the Cisco ATA to communicate with the correct
Cisco CallManager.
The .xml or .cnf file that the Cisco ATA downloads includes information about which signaling
image the Cisco ATA needs to function properly. The Cisco ATA finds that image on the TFTP
server and automatically downloads this image along with the corresponding version of Cisco ATA
release software.
If you are not using a Cisco CallManager TFTP server, you need to manually upgrade the
Cisco ATA to the correct signaling image. For information on this procedure, see the
"Upgrading the Signaling Image Manually" section on page
The Cisco ATA looks for a Cisco ATA-specific configuration file (designated by the MAC address
of the Cisco ATA and named ata<macaddress> with a possible extension) on the TFTP server and
downloads this file if it exists. For information about possible configuration file names, see the
"Configuration Files that the cfgfmt Tool Creates" section on page
If the Cisco ATA does not find the MAC-address configuration file, it looks for an atadefault.cfg
configuration file and downloads this file if it exists. This file can contain default values for the
Cisco ATA to use.
Cisco ATA 186 and Cisco ATA 188 Analog Telephone Adaptor Administrator's Guide for SCCP (version 3.0)

Specifying a Preconfigured VLAN ID or Disabling VLAN IP Encapsulation

"Voice Configuration Menu" section on page 3-22
Table 3-2 for a matrix that indicates which VLAN-related parameters
7-4.
3-14.
Table 3-1
for instructions
for a
3-3