Device Logs - Cisco 7985G - IP Phone NTSC Video Administration Manual

Chapter 8 Monitoring the Cisco Unified IP Video Phone Remotely

Device Logs

OL-8726-02
Table 8-4 Access Area and Network Area Items (continued)
Item
Tx Collisions
Tx excessLength
Tx broadcast
Tx multicast
The Device Logs area on a phone's web page provides information you can use to
help monitor and troubleshoot the phone.
The Status Messages area—Displays up to the 10 most recent status messages
•
that the phone has generated since it was last powered up. You can also see
this information from the Status Messages screen on the phone.
The Debug Display area—Displays a log of up to the 50 most recent alarms
•
for the phone. Alarms indicate a variety of errors or conditions.
alarm message numbers and their meanings.
To display the Status Messages or the Debug Display area, access the web page
for the phone as described in the
on page 8-2, and then click the Status Messages or the Debug Display hyperlink.
Table 8-5 Alarm Message Numbers and Explanations
Alarm Number Explanation
1 Configuration file that phone tried to obtain from the TFTP
server was too large (greater than 2 MB)
3 Firmware image that the phone tried to obtain has and
incorrect name
4 Phone's Flash memory is full
Description
Total number of collisions that occurred while a packet
was being transmitted
Total number of packets not transmitted because the
packet experienced 16 transmission attempts
Total number of broadcast packets transmitted by the
phone
Total number of multicast packets transmitted by the
phone
"Accessing the Web Page for a Phone" section
Cisco Unified IP Video Phone 7985G Administration Guide
Device Logs
Table 8-5 lists
8-11