Cisco 7937G - Unified IP Conference Station VoIP Phone Administration Manual page 42

Installing the Conference Station
To connect the conference station to the network using an optional external power source, perform the
following steps:
Procedure
1. Connect the external power
supply to the wall outlet.
Connect the other end of the
2.
external power supply to the
receptacle on the power
interface cable.
Connect the power interface
3.
cable to a network port.
Connect the other end of the
4.
power interface cable to a
Category 5 straight-through
Ethernet network cable.
Connect the end (without a
5.
ferrite bead) of a Category 5
straight-through Ethernet
network cable to the LAN
port on the underside of a
conference station.
Figure 3-3
station.
Figure 3-3
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
3-6
Notes
The external power supply is an optional
item. It is not included with the
conference station.
The power interface cable is an optional
item. It is not included with the
conference station.
Each conference station ships with one
Ethernet cable in the box.
shows how to connect the optional, external microphones to the back of the conference
Connection of Optional External Microphones to Conference Station
Chapter 3 Setting Up the Conference Station
Reference
See the "Power Guidelines" section on
page 2-3.
See the "Network Ports" section on page 3-3
for guidelines.
See the "Network Ports" section on page 3-3
for guidelines.
OL-11560-01 Rev. B0