Cisco 7937G - Unified IP Conference Station VoIP Phone Administration Manual page 41

Chapter 3 Setting Up the Conference Station
To install a conference station using PoE, perform the following steps:
Procedure
1. Connect the end (without a ferrite bead) of a Category 5
straight-through Ethernet network cable to the LAN port on
the underside of a conference station.
Connect the other end (with a ferrite bead) of a Category 5
2.
straight-through Ethernet network cable to a LAN port.
Figure 3-2
power supply.
Figure 3-2 Conference Station Cable Connections Using Optional External Power Supply
1
1
Connection of network cable to conference station RJ-45 port
2 Network cable (25-foot)
3 Connection of network cable to the power interface cable
4
Power interface cable
5
Connection of power interface cable to LAN wall port
6 Connection of power interface cable to external power supply
7 External power supply
8
Connection of external power supply to wall outlet
Cisco Unified IP Conference Station 7937G Administration Guide for Cisco Unified Communications Manager 6.0
OL-11560-01 Rev. B0
shows how to connect the conference station to the network if you use an optional external
3
2
Notes
Each conference station ships
with one Ethernet cable in the
box.
4
6
7
Installing the Conference Station
Reference
See the "Network Ports"
section on page 3-3 for
guidelines.
See the "Network Ports"
section on page 3-3 for
guidelines.
5
8
3-5