Manually Restarting The Controller Using The Reset Button - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Chapter 6 Restarting, Resetting, Backing Up, and Restoring the Controller
Step 9 When you are finished restoring controller configurations, click OK on the Configuration Archive
window.

Manually Restarting the Controller Using the Reset Button

The Reset button on the controller's front panel becomes active after the controller boots. You can use
the Reset button to reset power or to reset the configuration to factory defaults.
Figure 6-14
1
2
3
4
5
To restart the controller using the Reset button, follow these instructions:
Place a straightened paper clip into the Reset button hole (see
Step 1
While observing the controller LEDs, gently push and hold the Reset button with the paper clip.
Step 2
When the Status LED turn amber, release the Reset button by removing the paper clip.
Step 3
The controller configuration settings are not reset. If you have configured the controller, it reboots and
Step 4
loads the active configuration. If you have not configured the controller, the startup wizard GUI appears.
OL-15283-01
WLC526 Front Panel
1 2
AP ALARM
AP LED
Alarm LED
Status LED
Power LED
Distribution port 2

Manually Restarting the Controller Using the Reset Button

3 4
STATUS POWER
6 Distribution port 1
7 USB ports (not used)
8
Reset button
9 Console port
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
9
Cisco 520
Series Wireless LAN Controller
CONSOLE
2 1
1
2
5 6 7 8
Figure 6-14).
6-11