Verifying And Configuring Your Ethernet Adapter - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Chapter 2 Adding a WLC526 Controller and LAP521 Access Points
Figure 2-12
Click Close to exit the wizard.
Step 11
Remove your PC's Ethernet cable from the controller.
Step 12
Note
Mount your access point in the desired location. For mounting information refer to the Quick Start Guide:
Step 13
Cisco 526 Wireless Express Mobility Controller.
Connect a Category 5 Ethernet cable from the controller management interface port (1 or 2 as configured
Step 14
in Step
Your controller is now configured and ready to accept access point connections.

Verifying and Configuring Your Ethernet Adapter

To verify that your Ethernet adapter is configured to receive an IP address from a DHCP server on a
Windows-based PC, follow these instructions:
Click Start > Control Panel > Network Connections.
Step 1
Right-click on your Ethernet adapter and choose Properties.
Step 2
Scroll down the list of items and click Internet Protocol (TCP/IP).
Step 3
Click Properties and the Internet Protocol (TCP/IP) Properties screen appears.
Step 4
Ensure that Obtain an IP address automatically is checked.
Step 5
Click OK.
Step 6
OL-15283-01
Step 9 Summary Window Finish Status
Prior to using your PC and CCA to monitor your network, you need to reconfigure your PC
Ethernet adapter to a static IP address within the subnet of your network.
9, above) to your switch.
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Verifying and Configuring Your Ethernet Adapter
2-9