Using The Reset Button - Cisco 2505 Getting Started Manual

Figure 14 Access Points Connected to a Controller
Network
10/100/1000BASE-T
MDI cable
Cisco 2504 Wireless
Controller
Network
10/100/1000BASE-T
MDI cables
Cisco Access Points
Checking the Controller LEDs
If your 2504 controller is not working properly, check the LEDs on the front panel of the unit. You
can use the LED indications to quickly assess the status of the unit. See Table 1 on page 5 for a
description of the front panel LEDs.
The installation is complete. Refer to the Cisco Wireless Controller Configuration Guide for more
information about configuring your controller. The guide is available on cisco.com.

Using the Reset Button

The Reset button on the front panel of the controller becomes active after the controller boots. To reset
the controller using the Reset button, follow these steps:
Connect a PC to the controller console point.
Step 1
36