Using Cca To Convert An Ap521 Access Point - Cisco 521G - Unified IP Phone VoIP Configuration Manual

Appendix B Converting an Autonomous Access Point
Note
When the download completes, click Close.
Step 14
Step 15 Close your browser.

Using CCA to Convert an AP521 Access Point

CCA can be used to convert an AP521 access point into a lightweight LAP521 access point.
The CCA conversion process is a one-way process. CCA can only convert an AP521 into an LAP521.
Caution
CCA cannot reconvert an access point back to autonomous operation.
To convert an AP521 using CCA, follow these steps:
Check the topology view of your network to ensure an autonomous AP521 is available, such as
Step 1
Figure
Note
Note
Figure B-3
Step 2 Click Configure > Wireless > Convert to LAP and
OL-15283-01
Save the copy of the image file to the PC where CCA is installed if you plan to use the Standard
Mode when converting the access points (see
TFTP server if you plan to use Remote TFTP Server mode (See
B-3.
An autonomous access point is identified by a circle icon in a small box next to the access point,
such as the AP521 with an IP address of 192.168.10.23 in
An AP521 must be added to the community, before the Convert to LAP option is visible.
Network Topology View
Cisco 500 Series Wireless Express Mobility Controller Configuration Guide
Using CCA to Convert an AP521 Access Point
Figure B-6 on page B-5); save the copy to a remote
Figure B-7 on page
Figure B-3.
Figure B-4 appears.
B-5).
B-3