Skoda YETI - 11-2009 Owner's Manual page 66

Alternative park position of the rear window wiper
Each time after switching off the engine for the second time, the wiper blade of the rear
window wiper is tilted when the park position is activated. Thus, the life of the wiper
blade is prolonged.
Activating
– Switch on the ignition - position
– Push the operating level in the position
sion within 5 seconds.
– Switch off the ignition. After switching on the ignition again, the alternative park
position of the rear window wiper is activated.
– For deactivating the alternative park position of the rear window wiper, proceed in
the same way.
Headlight cleaning system*
The headlights are being cleaned after the windscreen has been sprayed for the first
time and fifth time, the low beam or main beam are switched on and the windscreen
wiper lever was held in the position
The headlight washer nozzles are moved forward out of the bumper by the water pres-
sure for cleaning the headlights.
You should remove stubborn dirt (such as insect residues) from the headlight lenses at
regular intervals, for example when refuelling. Please refer to the following guidelines
⇒ page 196, "The headlight lenses".
You should remove any snow from the fixtures of the washer nozzles and clear ice in
winter with a de-icing spray in order to ensure proper operation of the cleaning
system.
Using the system Safety
A ⇒ page 109.
2
A ⇒ page 63, fig. 57
five times in succes-
6
A ⇒ page 63, fig. 57
for about 1 second.
5
Driving Tips
Replacing wiper blades for the windscreen wipers
One cannot fold out the wiper arms in the rest position from the windscreen. Before
replacing the wiper arms you must put them into the service position.
Service position for changing wiper blades
– Close the bonnet.
– Switch the ignition on and then again off.
– Then press the windscreen wiper lever in the position
10 seconds - the wiper arms move into the service position.
Taking off the wiper blade
– Fold windscreen wiper arm away from the windscreen.
– Press the locking button, in order to unlock the wiper blade and pull off in the
⇒ fig.
direction of arrow 58.
Attaching a wiper blade
– Push the wiper blade until it locks up to the stop.
– Check whether the wiper blade is correctly attached.
– Fold the windscreen wiper arm back onto the windscreen.
The wiper arms move back into the rest position - after switching on the ignition and
after changing the position of the window wiper lever or when driving at a speed
greater than 6°km/h.
General Maintenance Breakdown assistance
Lights and Visibility
Fig. 58 Wiper blade for the windscreen
wiper
A ⇒ page 63, fig. 57
within
4
Technical Data
65