Skoda YETI - 11-2009 Owner's Manual page 243

242 Fuses and light bulbs
A
– Unscrew the securing screw
A
⇒ page 241, fig.
catches in direction of arrow
– Remove the plastic lamp holder.
– Replace the defective light bulb.
– In order to replace a bulb for the brake light, reversing light, rear fog or turn signal
light, turn the fixture of the bulb to the left up to the stop and take the bulb out of
the housing or pull the bulb for the parking light out of the fixture
fig. 204.
– Change the bulb, install again the fixture with the bulb in the housing and turn it to
the right up to the stop or insert it.
– Insert the plastic lamp holder into the illumination unit until the interlocks are
heard to engage and screw in the securing screw with the aid of the Torx wrench
⇒ page 241, fig.
204.
– Reconnect the plug connector and insert the bulb in the original position.
⇒ page 241, fig. 203
– Screw on the light
Fitting position of the light bulbs in the rear light unit
A
- Brake lights
1
A
- Reversing lights
2
A
- Rear fog light
3
A
- Turn signal lights
4
A
- parking lights
5
with the aid of the Torx wrench and press the three
204.
⇒ page 241,
on the left.
⇒ page 241, fig. 204
Licence plate light
– Unscrew the glass cover of the light
– Take the faulty bulb out of the holder and insert a new one.
– Replace the the glass cover of the light and press it down to the stop - ensure that
the glass cover is correctly installed.
– Screw the glass cover tight.
Fig. 205 Licence plate light
⇒ fig.
205.