Cruise Control System (Ccs) - Skoda YETI - 11-2009 Owner's Manual

Table of Contents

Advertisement

Park Assist: Speed too low.
After the ignition is switched on, the vehicle must exceed the speed of 10 km/h at least
once.

Cruise control system (CCS)*

Introduction
The cruise control system (CCS) maintains a constant speed, more than 30 km/h (20
mph), once it has been set, without you having to depress the accelerator pedal. This
is only possible within the range which is permitted by the power output and braking
power of the engine. The cruise control system makes it possible - particularly on long
journeys - for you to rest your "accelerator foot".
WARNING
The cruise control system must not, for safety reasons, be used in dense
traffic or on unfavourable road surfaces (such as icy roads, slippery roads or
loose chippings) - risk of accident!
In order to prevent unintentional use of the cruise control system, always
switch off the system after use.
Note
Models fitted with a manual gearbox: Always depress the clutch pedal if you switch
on the cruise control system when the gearbox is in Neutral. Otherwise the engine can
rev up unintentionally.
The cruise control system is not able to maintain a constant speed when driving on
steep downhill sections. The weight of the vehicle increases the speed at which it
travels. One should shift down in good time to a lower gear or slow the vehicle down
by applying the foot brake.
It is not possible on vehicles fitted with an automatic gearbox to switch on the
cruise control system if the selector lever is in the position P, N or R.
Using the system
Safety
Storing a speed
The cruise control system is operated by means of the switch
in the left lever of the multi-functional switch.
– Press the switch
– After the desired speed has been reached, press the rocker button
After you have released the rocker button
have just stored is maintained at a constant speed without having to depress the accel-
erator.
You can increase the speed by depressing the accelerator. Releasing the accelerator
will cause the speed to drop again to the set speed.
This does not apply, however, if you drive at a speed which is more than 10 km/h higher
than the set speed for a period of longer than 5 minutes. The stored speed will be
cancelled in the memory. You then have to re-store the desired speed.
One can reduce the speed in the usual manner. The system is switched off temporarily
by actuating the brake or clutch pedal ⇒ page 120.
First ensure that it is not too high for the traffic conditions which exist at that
moment before resuming the stored speed.
Driving Tips
General Maintenance
A
⇒ fig. 122
into the position ON.
A
position.
WARNING
Breakdown assistance
Starting-off and Driving
Fig. 122 Operating lever: Rocker button
and switch of cruise control system
A
and rocker button
A
A
into the SET
B
A
out of the position SET, the speed you
B
Technical Data
119
A
B

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Yeti

Table of Contents