Skoda YETI - 11-2009 Owner's Manual page 24

If the memory is set to zero (after disconnecting the battery), the fuel consumption of
10 ltr./100 km is calculated for the range; afterwards the value is adapted accordingly
to the style of driving.
Distance driven
The distance driven since the memory was last erased appears in the display
⇒ page 20. If you wish to measure the distance driven of a particular time, you must
set the memory to zero at this moment in time by pressing the button
⇒ page 21, fig. 19
shield wiper lever
⇒ page 21, fig.
steering wheel*
The maximum distance indicated in both switch positions is 9.999 km. The indicator is
set back to null if this period is exceeded.
Average speed
The average speed since the memory was last erased is shown in the display in
km/hour ⇒ page 20. If you wish to determine the average vehicle speed over a certain
period of time you must set the memory to zero at the start of the measurement using
A
the button on the windshield wiper lever
B
A
on the multifunction steering wheel*
D
A zero appears in the display for the first 100 m you drive after erasing the memory.
The indicated value will be updated every 5 seconds while you are driving.
Current speed*
The current speed which is identical to the display of the speedometer, is indicated on
A ⇒ page 16, fig.
the display
2
Oil temperature
The oil temperature appears in the display when the ignition is switched on. If there is
a fault, three lines are displayed instead of the temperature.
Using the system Safety
A
or the handwheel on the multifunction
D
19.
⇒ page 21, fig. 19
or with the handwheel
⇒ page 21, fig.
19.
15.
Driving Tips
Warning against excessive speeds*
A
on the wind-
B
Fig. 21 Warning against excessive speeds / multi-functional indicator: Control elements
This function enables you to set a speed limit, e.g. if you drive in town. A text in the
display is intended to draw your attention to the fact that you have exceeded the set
speed limit.
Warning against excessive speeds
– Select the menu point Speed warning --- km/h (warning at --- km/h)..
– Drive e.°g at a speed of 50 km/h.
– Press the button
on the multifunction steering wheel*
(warning at 50 km/h) is displayed in the information display*
increase or reduce this value with the button
by turning the handwheel
– The value is stored by repeated pressing of the button
lever or the handwheel
If you now exceed the set speed limit, Speed 50°km/h exceeded will be shown on the
display. This message is indicated for as long as the speed is reduced below the set
limit or switch off the message by pressing the button
⇒ fig. 21
or the handwheel
fig. 19.
An audible signal sounds as an additional warning signal.
The set speed limit remains stored even after switching off the ignition.
General Maintenance
Instruments and Indicator/Warning Lights
A ⇒ fig. 21
on the windshield wiper lever
B
⇒ page 21, fig.
19. Speed warning 50 km/h
A
on the windshield wiper lever or
A
A
on the multifunction steering wheel*.
D
A
on the multifunction steering wheel*.
D
A
on the windshield wiper lever
B
A
on the multifunction steering wheel*
D
Breakdown assistance
23
A
or the handwheel
D
⇒ fig.
21. You can
A
on the windshield wiper
B
⇒ page 21,
Technical Data