Attaching A Child Seat Using The "Isofix" System - Skoda YETI - 11-2009 Owner's Manual

WARNING (continued)
•
The shoulder part of the seat belt must run approximately across the middle
of the shoulder and fit snugly against the chest. It must on no account run
across the neck. The lap part of the seat belt must run across the pelvis and fits
snugly; it must not run over the belly. Tighten the belt webbing over your hip if
necessary.
•
Please comply with any differing national legal regulations regarding the
use of child safety seats.
Child safety seats in Group 3
For children of about 7 years of age weighing between 22 and 36 kg and of a height of
less than 150 cm, the optimal solution is a child safety seat (seat bolster) in combina-
tion with the three-point seat belt
Children of more than 150 cm in height may use the seat belts fitted to the vehicle
without a seat bolster.
WARNING
•
When transporting a child on the front passenger seat, please comply with
the appropriate national regulations regarding the use of child safety seats. If
required, the airbag has to be deactivated,
− in a specialist garage
Using the system Safety
Fig. 151 Child seat in Group 3 installed
on the rear seat facing the direction of
travel
⇒ fig.
151.
Driving Tips
WARNING (continued)
− or by using the switch for the front passenger airbag* ⇒ page 154,
"Switch for the front passenger airbag".
•
The shoulder part of the seat belt must run approximately across the middle
of the shoulder and fit snugly against the chest. It must on no account run
across the neck. The lap part of the seat belt must run across the pelvis and fits
snugly; it must not run over the belly. Tighten the belt webbing over your hip if
necessary.
•
Please comply with any differing national legal regulations regarding the
use of child safety seats.

Attaching a child seat using the "ISOFIX" system

Fig. 152 Locking eyes (ISOFIX system) / the ISOFIX child seat is pushed into the mounting
funnels
There are two fixing eyes* between the seat backrest and the seat cushion of the front
passenger seat for fixing the "ISOFIX" system child seat in place. The locking eyes on
the rear outside seats are located below the upholstery. The places are marked with
signs with the "ISOFIX" logo.
Install child seat
A
– Insert the mounting funnels
A
⇒ fig.
rest and the seat cushion
General Maintenance Breakdown assistance
Transporting children safely
A
onto the locking eyes between the seat back-
B
152.
Technical Data
161