Skoda YETI - 11-2009 Owner's Manual page 108

Using the system
So that the auxiliary heating (auxiliary heating and ventilation) func-
tions according to your expectations, it is necessary to carry out the
basic setting before its programming.
Basic setting
– On the information display, select from the Main menu the menu point
Aux. heating.
– In the menu Aux. heating (auxiliary heating)
Weekday and set the current day.
– By selecting the menu point Back, you will reach in the menu Aux. Heating
(auxiliary heating).
– In the menu Aux. Heating select the menu point Running time and set the
desired operating period in steps of 5 minutes. The operating period can be 10 to
60 minutes.
– By selecting the menu point Back, you will reach in the menu Aux. Heating
(auxiliary heating).
– In the menu Aux. heating (auxiliary heating) select the menu point Mode.
– In the menu Mode select the desired mode Heating or Ventilation.
Using the system Safety
Fig. 112 Information display:
Aux. Heating (auxiliary heating)
⇒ fig. 112
select the menu point
Driving Tips
Programming
For the programming of the auxiliary heating (auxiliary heating and ventilation) in the
menu Aux. heating (Aux. heating) there are three pre-set times:
•
Pre-set time 1
•
Pre-set time 2
•
Pre-set time 3
In each pre-set time, the day and the time (hour and minute) can be set for switching
on the auxiliary heating and/or ventilation.
An empty position can be found between Sunday and Monday when selecting the day.
If this empty position is selected, the activation is performed without taking into
account the day.
If you leave the pre-set menu by selecting the menu Back or do not make changes on
the display for longer than 10 seconds, the set values are stored, but the pre-set time
is not active.
Both other pre-set times can be programmed and stored in the same way.
If you select the menu Activate after setting the desired values, appears on the display
Pre-set time (weekday, hours, minute) activated! and the set pre-set time is active.
Only one programmed pre-set time can be active.
The last programmed pre-set time remains active.
After the auxiliary heating activates at the set time, it is necessary to pre-set a time
again.
Changing the active pre-set time is carried out after selecting the menu point Activate
in the menu Aux. heating (auxiliary heating) by selecting a pre-set time.
The prerequisite for the correct switching on of the auxiliary heating (auxiliary heating
and ventilation) according to the programmed pre-set time is the correct setting of the
current time and the weekday ⇒ page 107.
If the system is running, a warning light in the button for direct switching on/off of the
auxiliary heating lights up.

The running system deactivates after expiration of the operating period or is deacti-
vated earlier by pressing the button for direct switching on/off of the auxiliary heating
⇒ page 106.

General Maintenance Breakdown assistance
Heating and air conditioning system
Technical Data
107