Freecom VALUELOADER LTO User Manual page 53

Circular Mode On/Off
and is used only in sequential mode. When Circular Mode is on,
the ValueLoader reloads the original first cartridge in the sequence
after cycling through all available cartridges. If Circular Mode is
turned off and the last cartridge has been unloaded, the
ValueLoader stops loading cartridges until you manually load
another cartridge.
Use caution when choosing Circular Mode as it
Caution:
makes it possible to overwrite data on previously
written cartridges.
To access this option, follow these steps:
From the Home Screen or main menu, press the
1
until "Configuration" appears on the top line of the LCD
screen.
Press the
2 [Enter]
Press the or
3 [+] [-]
LCD screen. The second line displays the current status of this
mode.
Press to select. The LCD screen indicates whether you
4 [Enter]
are about to turn Circular Mode on or off.
Press the
5 [Enter]
or press
[Cancel]
Autoload Mode On/Off
and is only used when in Sequential Mode. When Autoload Mode
is on, the ValueLoader automatically loads the cartridge from the
lowest numbered full slot into the tape drive when powered on. It
then follows standard sequential operation as described in
Sequential Mode on page 38.
To access this option, follow these steps:
From the Home Screen or main menu, press the
1
until "Configuration" appears on the top line of the LCD
screen.
Press the
2 [Enter]
ValueLoader LTO Tape Autoloader User Manual
. This option turns Circular Mode on or off,
button to select.
button until "Circular Mode" appears on the
button to accept the change to Circular Mode
to exit and not save the changes.
. This option turns Autoload Mode on or off,
button to select.
ValueLoader Administration
Configuring the ValueLoader
or button
[+] [-]
or button
[+] [-]
39