Resetting The Valueloader; Changing The Scsi Id; Configuring The Valueloader - Freecom VALUELOADER LTO User Manual

ValueLoader Administration

Configuring the ValueLoader

Resetting the
3
ValueLoader
Changing the SCSI
3
ID
36
To access the Configuration menu from the Home Screen or main
menu, press the
[+]
the top line of the LCD screen. Press the
or to access the available options. Press the
[-]
execute the displayed menu option.
This option resets the ValueLoader robotics and the tape drive
within the ValueLoader, forces a new cartridge inventory, and
clears any current error condition.
This option is primarily used if the ValueLoader is in an
Note:
error state.
To access this option, follow these steps:
From the Home Screen or main menu, press the
1
until "Configuration" appears on the top line of the LCD
screen.
Press the
2 [Enter]
Press the or
3 [+] [-]
screen.
Press to reset the ValueLoader.
4 [Enter]
After initialization, the ValueLoader returns to normal operation
and displays the Home screen.
This option changes the SCSI IDs that the ValueLoader uses. The
ValueLoader operates as a dual SCSI device with two separate
SCSI IDs: one for the tape drive and the other for the ValueLoader
robotics.
The default SCSI IDs for the ValueLoader are 6 for the tape drive
and 5 for the robotics. You should only need to change the SCSI
IDs if there are other devices on the SCSI bus with the same SCSI
IDs.
ValueLoader LTO Tape Autoloader User Manual
or button until "Configuration" appears on
[-]
button to select.
button until "Reset" appears on the LCD
button and then
[Enter]
button to
[Enter]
or
[+] [-]
[+]
button