Sainlogic SC-07 User Manual page 23

Problem
Temperature sensor
reads too high in the
day time.
Indoor and Outdoor
Temperature do not
agree
Indoor and Outdoor
Humidity do not agree
Solution
If the sensor assembly is too close (less than
5ft), move the sensor assembly away from the
display console.
Make sure the remote sensor LCD display is
working and the transmitter light is flashing
once per 60 seconds.
Install a fresh set of batteries in the remote
thermo-hygrometer. For cold weather
environments, install lithium batteries.
Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
Move the display console around electrical
noise generating devices, such as computers,
TVs and other wireless transmitters or
receivers.
Move the remote sensor to a higher location.
Move the remote sensor to a closer location.
Make sure the thermo-hygrometer is mounted
in a shaded area. The pre preferred location is
a north facing wall because it is in the shade
most of the day.
Allow up to one hour for the sensors to
stabilize due to signal filtering. The indoor and
outdoor temperature sensors should agree
within 4 °F (the sensor accuracy is ± 2 °F).
Use the calibration feature to match the indoor
and outdoor temperature to a known source.
Allow up to one hour for the sensors to
stabilize due to signal filtering. The indoor and
23