Sainlogic SC-07 User Manual page 14

Note: If plugged into AC power, the time area will display AC ON and the
backlight will remain on.
If the automatic backlight setting is turned ON and the dimming is selected
as 0 (off), the backlight is automatically turned off during the set period.
For example, the backlight is set to automatically turn off from 8:01pm to
8:00am next day. During this period, to turn on the backlight temporarily for
five seconds, press the SNOOZE button.
7. Adjustment or Calibration
Note: The calibrated value can only be adjusted on the console.
Note: The measured humidity range is between 10 and 99%. Humidity
cannot be accurately measured outside of this range. Thus, the humidity
cannot be calibrated below 10% or above 99%.
The purpose of calibration is to fine tune or correct for any sensor error
associated with the devices margin of error. The measurement can be
adjusted from the console to calibrate to a known source.
Calibration is only useful if you have a known calibrated source you can
compare it against, and is optional. This section discusses practices,
procedures and sources for sensor calibration to reduce manufacturing
and degradation errors. Do not compare your readings obtained from
sources such as the internet, radio, television or newspapers. They are in a
different location and typically update once per hour.
The purpose of your weather station is to measure conditions of your
surroundings, which vary significantly from location to location.
7.1 Temperature Calibration
In normal mode, press and hold the SET/MODE and CHANNEL/+ keys at
the same time for five seconds to enter the temperature calibration mode.
The indoor temperature will begin flashing.
Press the [+] or [-] key to increase or decrease the temperature reading (in
increments of 0.1). Press and hold the [+] or [-] key for three seconds to
increase or decrease rapidly.
14