Sainlogic SC-07 User Manual page 15

Press the ALARM key to reset current value.
Press the SET/MODE key switch to sensor temperature calibrated mode.
Press the SET/MODE key switch to exit calibrated mode.To exit the
calibration mode at any time, press the SNOOZE button on the right side of
the display console. If no operation is performed, the calibration mode will
timeout in 30 seconds.
7.2 Humidity Calibration
In normal mode, press and hold the SET/MODE and HISTORY/- keys at
the same time for five seconds to enter the humidity calibration mode. The
indoor humidity will begin flashing.
Press the [+] or [-] key to increase or decrease the humidity reading (in
increments of 1%). Press and hold the [+] or [-] key for three seconds to
increase or decrease rapidly.
Press the ALARM key to reset current value.
Press the SET/MODE key switch to sensor humidity calibrated mode.
Press the SET/MODE key switch to exit calibrated mode.To exit the
calibration mode at any time, press the SNOOZE button on the right side of
the display console. If no operation is performed, the calibration mode will
timeout in 30 seconds.
Note: Humidity is a difficult parameter to measure accurately and drifts
over time. The calibration feature allows you to zero out this error. To
calibrate humidity, you will need an accurate source, such as a sling
psychrometer or Humidipaks One Step Calibration kit.
7.3 Pressure Calibration
In normal mode, press and hold the SET/MODE and ALARM keys at the
same time for five seconds to enter the pressure calibration mode. The
ABS of pressure will begin flashing.
Press the [+] or [-] key to increase or decrease the pressure reading.
Press and hold the [+] or [-] key for three seconds to increase or decrease
rapidly.
Press the ALARM key to reset current value.
Press the SET/MODE key switch to REL of pressure calibrated mode.
Press the SET/MODE key switch to exit calibrated mode. To exit the
calibration mode at any time, press the SNOOZE button on the right side of
15