Sainlogic SC-07 User Manual page 18

[-] key for three seconds to increase or decrease the alarm setting rapidly.
Press the ALARM key to turn on (the alarm icon will appear
the alarm.
To save the alarm setting and proceed to the next alarm parameter, press
(do not hold) the SET/MODE key.
Press the SNOOZE key twice at any time to return to the normal mode.
After 30 seconds of inactivity, the alarm mode will time out and return to
normal mode.
The following is a list of the individual alarm parameters that are set (in
order):
1.Alarm hour
2.Alarm minute
3.Sensor temperature high alarm
4.Sensor temperature low alarm
5.Sensor humidity high alarm
6.Sensor humidity low alarm
7.Sensor dew point high alarm
8.Sensor dew point low alarm
8.4 Alarm and Command Key Beeper ON/OFF Mode
The beeper can be silenced for both alarms and key strokes.
In normal mode, press and hold the HISTORY/- key for three seconds to
toggle the beeper on or off (depending on the current setting).
The BUZZ ON (beeper on) or BUZZ OFF (beeper off) icon will appear in
the time area for three seconds. Press and hold the HISTORY/- key again
for three seconds to toggle the BUZZ ON or BUZZ OFF command.
9. Other Console Features
The following section describes additional features and display icons.
9.1 Weather Forecasting
Note: The weather forecast or pressure tendency is based on the rate of
9.Indoor temperature high alarm
10.Indoor temperature low alarm
11. Indoor humidity high alarm
12.Indoor humidity low alarm
13.Absolute pressure high alarm
14.Absolute pressure low alarm
15.Relative pressure high alarm
16.Relative pressure low alarm
18
) and off