Configuring The Wi-Fi Band; Configuring Band Steering - Ruijie Reyee RG-APF1250 Configuration Manual

Configuration Guide
2.6

Configuring the Wi-Fi Band

(1) Go to the configuration page:

Method 1: Choose WLAN > Wi-Fi > Wi-Fi Settings. Select the target Wi-Fi.

Method 2: Choose WLAN > Wi-Fi > Wi-Fi List. Select the target Wi-Fi in the list and click Edit in the action
column.
(2) Set the band of Wi-Fi signals. The device supports the 2.4 GHz and 5 GHz bands. Compared with the 2.4
GHz band, the 5 GHz band supports a higher network transmission rate and is less susceptible to interference,
but is inferior in signal coverage and through-wall penetration. You can select an appropriate signal band
based on actual requirements. The default Wi-Fi band is 2.4G+5G, indicating that Wi-Fi signals are emitted
in both 2.4 GHz and 5 GHz bands.
2.7

Configuring Band Steering

Caution
This function can be enabled only after the dual-band integration (Band is set to 2.4G+5G) is enabled on the
Wi-Fi network. A client automatically selects a band only when the SSIDs of the 2.4 GHz and 5 GHz bands are
the same.
(1) Go to the configuration page:

Method 1: Choose WLAN > Wi-Fi > Wi-Fi Settings. Select the target Wi-Fi.

Method 2: Choose WLAN > Wi-Fi > Wi-Fi List. Select the target Wi-Fi in the list and click Edit in the action
15
Wi-Fi Network Settings