Ruijie Reyee RG-APF1250 Configuration Manual page 21

Configuration Guide
Parameter
Wi-Fi Standard
Wireless
Schedule
VLAN
Hide SSID
Client Isolation
Band Steering
XPress
Layer 3
Roaming
2.3 Configuring SSID and Wi-Fi Password
(1) Go to the configuration page:

Method 1: Choose WLAN > Wi-Fi > Wi-Fi Settings. Select the target Wi-Fi.

Method 2: Choose WLAN > Wi-Fi > Wi-Fi List. Select the target Wi-Fi in the list and click Edit in the action
column.
(2) Enter the SSID, select the encryption type, enter the Wi-Fi password of the Wi-Fi network, and click Save. If
the encryption type is set to Open, the Wi-Fi network is an open network, and clients can connect to the
Description
Wireless mode, including 802.11be (Wi-Fi 7), 802.11ax (Wi-Fi 6), and compatible mode
802.11be (Wi-Fi 7): This parameter takes effect only on APs that support the IEEE
802.11be protocol. In addition, the connected terminals must support the IEEE 802.11be
protocol to experience the high-speed Internet access experience brought by Wi-Fi 7.
802.11ax (Wi-Fi 6): This parameter takes effect only on APs that support the IEEE
802.11ax protocol. In addition, access clients must support IEEE 802.11ax so that users
can enjoy high-speed Internet access experience brought by Wi-Fi 6.
Compatibility mode: The AP supports 802.11n (Wi-Fi 4) in the 2.4 GHz band and 802.11ac
(Wi-Fi 5) in the 5 GHz band. The AP has good compatibility with STAs that do not support
Wi-Fi 6 and above.
Specify the time periods during which Wi-Fi is enabled. After you set this parameter, users
cannot connect to Wi-Fi in other periods.
Set the VLAN to which the Wi-Fi signal belongs. You can select User and AP in the same
VLAN or Other VLAN and enter the VLAN ID.
Enabling the Hide SSID function can prevent unauthorized user access to Wi-Fi, improving
security. However, mobile phones or computers cannot find the Wi-Fi name after this
function is enabled. You must manually enter the correct name and password to connect to
Wi-Fi. Record the current Wi-Fi name before you enable this function.
After this function is enabled, clients associated with the Wi-Fi are isolated from one other,
and end users connected to the same AP (in the same network segment) cannot access
each other. This improves security.
After this function is enabled, the client supporting 5 GHz selects the 5G Wi-Fi network
preferentially. You can enable this function only when Band is set to 2.4 GHz + 5 GHz.
After this function is enabled, the device sends game packets preferentially, providing more
stable wireless network for gaming.
After this function is enabled, clients keep their IP addresses unchanged when associating
with the same Wi-Fi. This function improves the roaming experience of users in the cross-
VLAN scenario.
12
Wi-Fi Network Settings