Ruijie Reyee RG-APF1250 Configuration Manual page 42

Configuration Guide
3
Network Settings
Note
This chapter takes the currently logged in device as an example to describe the entry of each function setting
page. If you need to configure other devices in the network, please refer to the following path to enter the
configuration page of the corresponding device, and then configure the function. Choose WLAN > APs. Select
the target device in the device list and click Manage.
3.1 Switching Work Mode
3.1.1 Work Mode
See 1.3 Work Modes
3.1.2 Self-Organizing Network Discovery
You can set whether to enable the self-organizing network discovery function. This function is enabled by default.
After the self-organizing network discovery function is enabled, the device can be discovered in the network and
discover other devices in the network. Devices network with each other based on the device status and
synchronize global configuration. You can log in to the web interface of any device in the network to check
information about all devices in the network. After this function is enabled, clients can maintain and manage the
current network more efficiently. You are advised to keep this function enabled.
If the self-organizing network discovery function is disabled, the device will not be discovered in the network and
it runs in standalone mode. After logging in to the Web page, you can configure and manage only the currently
logged in device. If only one device is configured or global configuration does not need to be synchronized to
the device, you can disable the self-organizing network discovery function.
3.1.3 Configuration Steps
Choose WLAN > APs > Manage > Device Overview > Device Info.
Click the current work mode to change the work mode.
for details.
33
Network Settings