Danfoss VLT FCD 302 Operating Manual page 7

Operating Guide | VLT® Decentral Drive FCD 302
1 Introduction and Safety
1.1 Purpose of this Operating Guide
This operating guide provides information for safe installation and commissioning of the product. It is intended for use by qualified
personnel. To use the drive safely and professionally, read and follow the instructions. Pay particular attention to the safety instructions
and general warnings. Always keep this operating guide available with the product.
1.2 Additional Resources
Other resources are available to understand advanced drive functions and programming.
The VLT® Decentral Drive FCD 302 Design Guide provides detailed information about the capabilities and functionality to design motor
l
control systems.
The VLT® AutomationDrive FC 301/302 Programming Guide provides greater detail on working with parameters and many application
l
examples.
The VLT® PROFIBUS DP-V1 MCA 101 Programming Guide provides greater detail on programming the VLT® drive using the PROFIBUS®
l
DP communication protocol.
The VLT® Frequency Converters Safe Torque Off Operating Guide provides greater detailed information about the Safe Torque Off (STO)
l
function, the related installation, and commissioning.
Instructions for operation with optional equipment.
l
Supplementary publications and guides are available at www.danfoss.com.
1.3 Trademarks
VLT® is a registered trademark of Danfoss A/S
l
DrivePro® is a registered trademark of Danfoss A/S.
l
PROFIBUS® and PROFINET® are registered trademarks of PROFIBUS and PROFINET International (PI).
l
1.4 Document and Software Version
This guide is regularly reviewed and updated. All suggestions for improvement are welcome.
The original language of this guide is English.
Table 1: Document and Software Version
Edition
AQ267036816112, version 0301
1.5 Approvals
1.5.1 Type Approvals and Certifications
Table 2 shows examples of possible type approvals and certifications for Danfoss drives.
Danfoss A/S © 2025.04
Remarks
New document structure.
Editorial update.
Introduction and Safety
Software version
9.X.X
AQ267036816112en-000301 / 130R0208 | 7