Power Switch/LED Assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Lay the computer on its side with the front facing toward you.
4.
Remove the front bezel
5.
Remove the optical drive
6.
Disconnect the braided cables from the system board.
7.
Remove the cable from the clips in the optical drive cage.
8.
Press the tabs near the bottom on both sides of the switch holder (1) to disengage it from the
chassis, rotate the bottom of the switch upward (2), and then pull it away from the chassis while
guiding the wires through the hole in the chassis.
Figure 2-44
To install the power switch/LED assembly, reverse the removal procedures.
34
Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis
(Access Panel on page
(Front Bezel on page
(Removing an Optical Drive on page
Removing the power switch
(Preparation for Disassembly on page
5).
7).
4).
25).