Solving Memory Problems - HP 510B - Minitower PC Maintenance And Service Manual

Diagnostics reports a failure.
Cause
Network controller interrupt is shared with an expansion
board.
The network controller is defective.
Network controller stops working without apparent cause.
Cause
The files containing the network drivers are corrupted.
The cable is not securely connected.
The network is temporarily unavailable.
Cannot connect to network server when attempting Remote System Installation.
Cause
The network controller is not configured properly.

Solving Memory Problems

If you encounter memory problems, some common causes and solutions are listed in the following
table.
System will not boot or does not function properly after installing additional memory modules.
Cause
Memory module is not the correct type or speed grade for
the system or the new memory module is not seated
properly.
The memory module is not correctly seated.
Solution
Under the Computer Setup Advanced menu, change the
resource settings for the board. Check that they are different
from those of the network controller.
Disable the integrated network controller from the setup
utility and install a new network interface card.
Solution
Reinstall the network drivers.
Ensure that the cable is securely attached to the network
connector and that the other end of the cable is securely
attached to the correct device.
Contact the network administrator to find out the status of the
network.
Solution
Verify that the computer is properly connected to the
network, that a DHCP Server is present, and that the
Remote System Installation Server contains drivers for the
network controller.
Solution
Replace module with the correct industry-standard device for
the computer. Do not mix ECC and non-ECC memory
modules.
Open the casing and reseat the DIMM.
Solving Memory Problems
81