Power Switch/Led Assembly - HP ProDesk 400 G1 Maintenance And Service Manual

Power switch/LED assembly

Description
Power switch/LED assembly
1.
Prepare the computer for disassembly
2.
Remove the access panel
3.
Remove the front bezel
4.
Disconnect the cable from the system board connector labeled PB/LED.
NOTE:
5. Press down on the top of the assembly to disengage the tab (1) that secures the assembly to the
chassis.
78 Chapter 5 Removal and replacement procedures: Microtower
(Access panel on page
(Front bezel on page
System board appearance may vary.
(Preparation for disassembly on page
43).
44).
Spare part number
745050-001
42).