Processor (Amd) - Model 505B/515B - HP 510B - Minitower PC Maintenance And Service Manual

Processor (AMD) — Model 505B/515B
1. Prepare the computer for disassembly
2. Remove the access panel
3. Disconnect the heatsink control cable from the system board and remove the heatsink
assembly (AMD) — Model 505B/515B on page
4. Rotate the locking lever to its full open position (1).
5. Carefully lift the processor from the socket (2).
CAUTION:
handling them could cause irreparable damage. Once pins are damaged it may be necessary to
replace the system board.
The heat sink must be installed within 24 hours of installing the processor to prevent damage to
the processor's solder connections.
Figure 2-49
To install a new processor:
1. Place the processor in its socket and close the retainer.
2. Secure the locking lever.
If reusing the existing heat sink, go to step 3.
If using a new heat sink, go to step 5.
3. If reusing the existing heat sink, apply the thermal grease provided in the spares kit to the top of
the processor.
4. Clean the bottom of the heat sink with the provided alcohol pad and place it atop the processor.
40 Chapter 2 Removal and Replacement Procedures Microtower (MT) Chassis
(Access Panel on page
Do NOT handle the pins in the processor socket. These pins are very fragile and
Removing an AMD processor
(Preparation for Disassembly on page
5).
37).
4).
Heat sink