Replacing a Hard Drive
1.
Follow the steps in
2.
Slide the replacement hard disk drive into the bay.
NOTE:
old drive to install the new drive.
Figure 2-39
3.
Align the screw holes on the side of the hard drive with the holes marked "HDD" on the bay.
Figure 2-40
CAUTION:
sharp bend can break the internal wires.
Removing a Hard Drive on page 28
If you are replacing an old drive with a new drive, use the four retainer screws from the
Installing the hard drive
Align the screw holes
Never crease or bend a SATA data cable tighter than a 30 mm (1.18 in) radius. A
to remove the hard drive.
Drives
31