Computer Setup-Exit; Model 505B/515B - Computer Setup (F10) Utilities - HP 510B - Minitower PC Maintenance And Service Manual

Computer Setup—Exit
NOTE: Support for specific Computer Setup options may vary depending on the hardware
configuration.
Table A-5
Option
Exit Saving Changes
Exit Discarding
Changes
Load Setup Defaults
Discard Changes
Save Changes
Model 505B/515B — Computer Setup (F10) Utilities
Use Computer Setup (F10) Utility to do the following:
●
Change factory default settings.
●
Set the system date and time.
●
Set, view, change, or verify the system configuration, including settings for graphics, audio,
storage, communications, and input devices.
●
View settings for processor and memory.
●
Modify the boot order of bootable devices such as hard drives, diskette drives, optical drives, or
USB flash media devices.
●
Restrict a device from booting the unit.
●
Run hard drive self-tests.
●
Establish a supervisor password that controls access to Computer Setup (F10) Utility and the
settings described in this section.
● Enable or disable removable media boot ability.
58 Appendix A Computer (F10) Setup
Computer Setup—Exit
Description
Press Enter to exit saving changes.
Press Enter to exit discarding changes.
Press Enter to load setup defaults.
Press Enter to discard changes.
Press Enter to save changes.